Lenovo V100 Hardware Maintenance Manual page 34

Checkout guide
Note: If the battery pack becomes hot, it may not be able to charge. Remove it
To check the battery pack, do the following:
1. Power off the computer.
2. Remove the battery pack and measure the voltage between battery terminals 1
3. If the voltage is less than +11.0 V dc, the battery pack has been discharged.
4. If the voltage is more than +11.0 V dc, measure the resistance between battery
28
MT 0763 and 0764
from the computer and leave it at room temperature for a while. After it
cools down, reinstall and recharge it.
(−) and 7 (+). See the following figure:
7(+)
6(+)
5
4
3
2(-)
1(-)
Note: Recharging will take at least 3 hours, even if the indicator does not turn
on.
If the voltage is still less than +11.0 V dc after recharging, replace the battery.
terminals 4 and 7. The resistance must be 4 to 30 K .
If the resistance is not correct, replace the battery pack. If the resistance is
correct, replace the system board.
Terminal Voltage (V dc)
1, 2 Ground (−)
6, 7 + 0 to + 12.6