Superior DRT3033 Installation And Operation Instructions Manual page 61

Innovative Hearth Products
Superior DRT3000 Series Direct-Vent Gas Fireplaces
TM
MAINTENANCE SCHEDULE
See the tables below for detailed information about required maintenance, both regular and annual.
Table 38: Maintenance Performed Annually—Before the Burning Season
Maintenance Task
Inspecting/Cleaning Burner, Logs
and Controls
Checking Flame Patterns and
Flame Height
Inspecting/Cleaning Pilot and Burner
Checking Vent System
Fireplace Inspection
Replacing Glowing Embers
Replacing Batteries
Table 39: Maintenance Performed Periodically—After the Burning Season
Maintenance Task
Cleaning Firebox Interior
Check Flame Patterns and Flame Height
Checking Vent System
Cleaning Glass Door
Performed By
Qualified Service Technician
Qualified Service Technician
Qualified Service Technician
Qualified Service Technician
Qualified Service Technician
Homeowner/Qualified Services Technician
Homeowner/Qualified Services Technician
Performed By
Homeowner
Homeowner
Homeowner
Homeowner
Procedure
Inspect valve and ensure it is properly
operating. Check piping for leaks. Vacuum
the control compartment, fireplace logs and
burner area.
Verify the flame pattern and height displayed
by the fireplace (Figure 39 and Figure 40).
Flames must not impinge on the logs.
Remove any surface build-up on pilot and
burner assembly. Wipe the pilot nozzles,
igniter/flame rod and hood. Ensure the pilot
flame engulfs the flame sensor as shown.
Inspect the vent system at the top and at
the base (within the firebox) for signs of
blockage or obstruction. Look for any signs
of dislocation of the vent components.
Perform the appropriate fireplace inspection
procedure detailed in this manual.
Remove the old glowing embers and
vacuum the area. Place new glowing embers
(Figure 48).
Replace the eight (8) batteries in the battery
holders.
Procedure
Carefully remove logs, volcanic stone and
glowing embers / glass media. Vacuum out
interior of the firebox. Clean firebox walls and
log grate, if installed. Replace removed items
as detailed in this manual.
Verify the flame pattern and height displayed
by the fireplace (Figure 39 and Figure 40).
Flames must not impinge on the logs.
Inspect the vent system at the top and at
the base (within the firebox) for signs of
blockage or obstruction. Look for any signs
of dislocation of the vent components.
Clean as necessary following the directions
provided in this manual (Page 59). Do not
touch or attempt to clean the glass while hot.
Operation
900285-00 11/2014
61