Install The Hood; Install The Finishing Materials - Superior DRT3033 Installation And Operation Instructions Manual

Innovative Hearth Products
Superior DRT3000 Series Direct-Vent Gas Fireplaces
TM
Figure 39: Fireplaces Flame Appearance
Table 29: Main Burner Shutter Opening—Factory Setting

Install the Hood

19.
NOTE: All models must have a hood installed prior to operation.
1. Install the hood by sliding it into the slots on the lower edge of the cabinet top.
NOTE: To install the non-combustible finish material flush with the top of the hood, the hood must be installed
before installing the finish material. If finish material is installed flush with the top edge of the hood, the hood cannot
be removed.
NOTE: To install the hood after installing the non-combustible finish material over the black surface above the
fireplace opening, the bottom edge of the finish material must be 5/8" above the top edge of the hood to allow
clearance for installation and removal of the hood.
Reinstall the Included Barrier
20.
Reinstall any barrier removed before operating the fireplace. The barrier is designed
to reduce the risk of burns from hot glass. Do not operate the fireplace without the
barrier installed.
NOTE: All models must have a barrier installed prior to operation.
1. Open the control compartment door (Page 52).
2. Hold the barrier in front of the glass door and slide it up into the slots above the glass door and under the hood.
3. Slide the barrier bottom down into the slots below the glass door, securing it in place.

Install the Finishing Materials

21.
1. Complete finished interior wall.
NOTE: To install the fireplace facing flush with the finished wall, position framework to accommodate the thickness
of the finished wall.
42
Models
All
Natural Gas
1/16"
(1.6 mm)
WARNING
Installation
900285-00 11/2014
Propane
1/8"
(3.2 mm)