5
Position the lower shell onto the connector as shown in
Figure 5-6 Lower Shell Placement
6
Attach the upper shell to the lower shell and tighten it using a #1 Phillips head screwdriver (see
Figure
5-6).
Figure 5-7 Upper Shell Attachment
7
Clamp the ferrite onto the cable next to the connector that will be connected to the rear panel
(pro-panel) as shown in
Figure 5-8 Ferrite Placement
If the ferrite is loose on the cable, use a tie wrap to hold it in place.
Figure
5-8.
NEXIO AMP
Hardware Installation and User Guide
Figure
5-6.
49