Imagine Nexio AMP NX3601 HDX Hardware Installation And User's Manual page 47

NEXIO AMP MDR Connector Assembly
1 Use a wire stripper to remove approximately 1/16" of the wire insulation from each of the required
conductors (see
Table 5-5 shows the jumper settings for NEXIO AMP RS-422 and GPI Board.
Table 5-5 Jumper Settings for RS-422 and GPI Board
Jumper Descriptions
JP1 Debug Enable/Disable
JP2 Board Enumeration
JMP1 Power Input
JMP2 Optoisolator Power Select
In normal operating conditions, no jumper setting changes are required.
This section describes the procedure for assembling a NEXIO AMP MDR connector.
To assemble a MDR connector
Figure 5-3).
Figure 5-3 Stripped Wires
Hardware Installation and User Guide
Modes
OFF = Enable ON = Disable
OFF = Board1; ON = Board2
1-2 = External; 2-3 = USB
1-2 Internal; 2-3 = External
NEXIO AMP 47