Imagine Nexio AMP NX3601 HDX Hardware Installation And User's Manual page 22

22
Chapter 2
Hardware Installation
1 In NEXIO Config, click the IP Config tab (see
2 In the Role list, select NXLAN 1 for Ethernet 1.
1 In NEXIO Config, click the IP Config tab (see
2 In the Role list, select Not Assigned for all Ethernet connections.
3 In the Hi-Res Net Server (MIOH) area, enter the IP address for Host 1 and Host 2.
NEXIO AMP
The possible Ethernet port allocations for the NEXIO AMP are shown in
Table 2-2 Ethernet Port Allocations for NEXIO AMP
Ethernet
1, 2
FTP
Port

1

2

3

4
1
Gigabit Ethernet is required.
2
No Teaming allowed.
Standard Ethernet Configuration
The following sections describe the configurations for physical ports Ethernet 1
and Ethernet 2 when used in the standard network configuration.
If you need to enter values for Ethernet 3 or higher, enter the appropriate IP address(es) in
the NEXIO Config — LLM tab, NetDiskServer boxes (see
Ethernet 1 Port Configuration (default)
The following shows the default configuration from the factory:
Configured as the NEXIO LAN communications port

Preferred port for Ethernet based automation control (G1 only)

If you are using a direct connection:
If you are using a Media Host architecture:
FTP with Ethernet
The FTP Server can move both SD and HD content in and out of the server system.
The following rules apply for when moving content in and out of a server mainframe via
FTP:
FTP Server module must be running on the mainframe that is used to move clips in and

out of the server system.
The FTP client controlling the transfer process may run on any computer that has

connectivity to the Ethernet port bound to the FTP service.
FTP cannot use the same Ethernet port as the low resolution proxy (PRXEncoder).

LLM
page 74).
page 74).
Table 2-2.
on page 81).