We do not advise the use of furniture cleaning sprays or polishes as they can cause indelible white marks if the unit is subsequently wiped with a damp cloth. CD62 CD62 9. Power sources Only connect the appliance to a power supply of the type described in the operating instructions or as marked on the appliance.
This handbook has been designed to give you all the information you need to install, connect, set up and use the Arcam CD62 compact disc player. The CR224 remote control handset supplied with this equipment is also described, as it applies to operating the CD62.
(120V or 230V) indicated on the rear panel of the unit. If your mains supply voltage or mains plug is different, consult your Arcam dealer or Arcam Customer Support on +44 (0)1223 203203. Mains lead The appliance is normally supplied with a moulded mains plug already fi...
Using your CD player CD62 24 BIT DAC POWER Press this button to switch the CD player on and off. When fi rst powered up with no CD installed the display shows: --NO DISC-- LOAD To install a CD, press LOAD ( The CD tray opens –...
Opens and closes the CD tray. Source selection These operate in the same way as the source selector on the front panel of an Arcam integrated amplifi er. CD62 0–9 keypad This allows direct access to individual tracks on the disc.
This means that designs and specifi cations are subject to change without notice. Radio interference The CD62 is a digital audio device which has been designed to very high standards of electromagnetic compatibility. The CD player and DAC generate, and can radiate RF (radio frequency) energy.
You can register your Arcam product on line at: www.arcam.co.uk/reg PEMBROKE AVENUE, WATERBEACH, CAMBRIDGE CB5 9PB, ENGLAND telephone +44 (0)1223 203203 fax +44 (0)1223 863384 email support@arcam.co.uk website www.arcam.co.uk Issue 1 It should be sent carriage prepaid by a reputable carrier -–...