Table of Contents
Advertisement
CLEANING ( ( continued)
PAINTED AREAS - These can be cleaned using a dry cloth.
STAINLESS S S TEEL A A REAS - These areas may be cleaned using a soft damp cloth or stainless steel cleaner.
IMPORTANT - Always clean in the direction of the grain, and never across it as this will scratch the surface. It is
recommended that a small inconspicuous area is attempted before cleaning the entire stainless steel area - to
ensure the cleaning material is suitable.
LOGS A A ND CERAMICS - Carefully remove the ceramic components. Gently clean in the open air. Be careful not
to create dust from the logs or pebbles. Where necessary replace damaged components with genuine spares.
Seal scrap components in plastic bags and dispose of at proper refuse sites as directed.
Re-fit the logs carefully by referring to the relevant section of these instructions.
GLASS C C RYSTALS - If necessary, the glass crystals may be removed from the firebowl and cleaned in lukewarm
mild soapy water. Rinse thoroughly in clean water and ensure the glass in completely dry before refilling.
Important - W W ear p p rotective g g loves w w hen h h andling t t he g g lass c c rystals.
9.0
LIST OF SPARES
PA A RT N N O.
CE/F550060
CE/F550061
CE/F780019
CE/F780037
CE/F550071
CE/F920006
FR/005480-0
FT/F730015
FT/F730006
FT/F730016
FT/F870009
ITEM
Pack of 8 large ceramic logs (Log Version Only)
Pack of 6 small ceramic logs (Log Version Only)
Ceramic log support (Log Version Only)
Bag of vermiculite (Log Version Only)
Pack of 10 individual Ceramic Pebbles (Glass/pebble models only)
Pack of heat resistant Glass Crystals (Glass/pebble models only)
3 piece Marble frame
Control valve
ODS pilot unit
Injector
Control knob
Advertisement
Table of Contents
