XRPlus XRS 2004 Series User Manual page 12

3. Installation
② Connect IDE Cable to Hard Disk
One HDD Installation
③ After Finishing Cable Connection, Attach Hard Disk with Screw & Bracket
• Insert Disk, Red Cable Head to Power Cable Plug
• Connect Power Cable to Hard Disk in the Same Way
※ If One HDD Install, Connect with End of Connector (Black)
Recommended.
If Add HDD, Connect with Middle Connector (Gray)
Recommended.
Two HDD Installation
Tip
For Rear Panel
• When Install Master HDD, Please Connect
1 at IDE1 Port by Master Cable.
• It means, Master Connector which
1 Connected with IDE1 Cable Must
1 Connected with HDD (Master).
ㅡMaster, Slave?
• IDE Hard Disk can connect two equipment at one
cable (port). For the purpose of prevent confusing,
two equipment named 'Master' & 'Slave'. 'Master'
is one hard disk or first hard disk and 'Slave' is
below second hard disk.
12
Bracket Installation
IDE2 IDE1