Chapter 3. Installation; Hard Disk Installation - XRPlus XRS 2004 Series User Manual

3. Installation

1. Hard Disk Installation

① Jumper Setup as Master or Slave
※ Example of Samsung HDD Jumper Setup
② IDE Cable Connection to Main Board
• Jumper Setup as master or Slave, Following the
` Direction of Surface of Hard Disk.
• Jumper Located at Hard Disk Data Cable or
1 Rear Side of Hard Disk.
• If One Hard Disk Installation, Setup as Master
If Two Hard Disk Installation, Second One Setup as Slave.
‼ When Hard Disk Add or Exchange,
Properly (System Off by Power
Cause of Fatal Hard Disk Error.‼
• Refer to General Pin Setting in Jumper Pin Setting on HDD Surface.
• When One HDD Install, Setup Pin as Master and Connect Pin
1 at the Left End of Jumper.
• When Two HDD Install or Additional Install, First One Setup as
1 Master and the Other is for Slave. Slave Setup has No Pin.
• When More than Two HDD install, Setup as Master or Slave
1 to Connect One IDE Cable at the Same Method of Above.
!!Please Use Hard Disk which Possible to Supply Higher than
UDMA66.!!
• Confirm the IDE Cable Inside of Product
• Among the Three Connector, Indicated Blue Color
1 Connector Must be Connected with Main Board.
Other 1 Connectors Connected with HDD
11
Must System Off
Button). If not, it's a