TP-Link TD-W8950ND User Manual page 40

TD-W8950ND
default gateway for DHCP client connected to it. Keep in mind that if you change the IP
address of the modem router, you must change the range of IP addresses in the pool used for
DHCP on the LAN.
• Start IP Address: Enter a value for the DHCP server to start with when issuing IP
addresses. Because the default IP address for the modem router is 192.168.1.1, the
default Start IP Address is 192.168.1.2, and the Start IP Address must be 192.168.1.2 or
greater, but smaller than 192.168.1.254.
• End IP Address: Enter a value for th
addresses. The End IP Address must be smaller than 192.168.1.254. The default End IP
Address is 192.168.1.254.
• Leased Time (hour): The L
be allowed connection to the modem router with their current dynamic IP address. Enter
the amount of time, in hours, then the user will be "leased" this dynamic IP address. After
the dynamic IP address has expired, the user will be automatically assigned a new
dynamic IP address. The default is 24 hours.
Static IP Lease List: The function allows you to s
LAN, that PC will always obtain the assigned IP address each time when it accesses the
DHCP server. Reserved IP addresses should be assigned to servers that require permanent
IP settings. Click the Add Entries button, and then you will set the rule in the screen as
below.
• MAC Address: The MAC address of the computer on the LAN which you want to reserve
an IP.
• IP Addr
ess: The IP address you want to reserved to the computer.
Configure the second IP Address and Subnet Mask: You can
router's second IP Address and Subnet Mask for LAN Interface through which you can also
access to the Web-based Utility as the default IP Address and Subnet Mask.
150Mbps Wireless N ADSL2+ Modem Router User Guide
e DHCP server to end with when issuing IP
eased Time is the amount of time in which a network user will
pecify a reserved IP address for a PC on the
Figure 4-22
32
configure the modem