Cleaning The Oven Door; Catalytic Cleaning - Zanussi ZOA35525 User Manual

CAUTION!
Be careful when you remove the
shelf supports. The catalytic panels
are not attached to the oven walls
and can fall out when you remove
the shelf supports.
1
Pull the front of the
1
shelf support away
from the side wall.
Hold the rear shelf
runners and catalytic
panel in place with
the other hand.
Install the shelf supports in the opposite
sequence.
The retaining pins on the telescopic
runners must point to the front.

Catalytic cleaning

CAUTION!
Do not clean the catalytic surface
with oven sprays, abrasive cleaning
agents, soap or other cleaning
agents. This will damage the
catalytic surface.
Spots or discolouration of the
catalytic surface have no effect on
catalytic properties.
WARNING!
Keep children away when you clean
the oven at a high temperature. The
oven surface becomes very hot and
there is a risk of burns.
Before activating the catalytic
cleaning remove all the accessories
from the oven.
The walls with a catalytic coating are self-
cleaning. They absorb fat which collects on the
walls while the appliance operates.
www.zanussi.com
2
1
2
Pull the rear end of
2
the shelf support
away from the side
wall and remove it.
To support the self-cleaning procedure, heat
the empty oven on a regular basis.
1. Clean the oven floor with warm water and
washing up liquid, then dry it.
2. Set the function
3. Set the oven temperature to 250 °C and let
the oven operate for 1 hour.
4. When the appliance is cool, clean it with a
soft and moist sponge.

Cleaning the oven door

The oven door has two glass panels. You can
remove the internal glass panel to clean it.
CAUTION!
Do not use the appliance without the
internal glass panel.
The direction in which you open the
door depends on your oven model.
You open the door from the right
side in some models and from the
left side in others.
1
A
Press the buttons at
1
the sides of the door
trim (A) on the upper
cover and pull it
upwards to remove it.
Clean the door with a wet sponge and rub it dry
with a soft cloth. Do not use steel wool, acids or
abrasive cleaning agents because they can
damage the surface.
When the oven door is clean, install the glass
panel in the opposite sequence. The screen-
printing zone must face the inner side of the
door. Make sure that after the installation the
surface of the glass panel frame on the screen-
printing zones is not rough when you touch it.
Make sure that you put the glass panel in the
rubber distance holders.
.
B
2
Hold the inner glass
2
B tightly with both
hands and slide it
upwards to remove it
from its initial
position. Make sure
that you tightly hold
glass B to prevent
the glass from falling.
17