Zte MF25A User Manual

LEGAL INFORMATION
Copyright © 2013 ZTE CORPORATION.
All rights reserved.
No part of this publication may be excerpted, reproduced, translated or
utilized in any form or by any means, electronic or mechanical, including
MF25A
photocopying and microfilm, without the prior written permission of ZTE
Corporation.
Let's go
The manual is published by ZTE Corporation. We reserve the right to
make modifications on print errors or update specifications without prior
Getting started with your device.
notice.
Version No. : R1.0
ZTE CORPORATION
NO. 55, Hi-tech Road South, ShenZhen, P.R.China
Postcode: 518057
Connecting Your Device
WLAN works normally with no data
ON
transmission..
Follow the number to connect your device.
NOTE: WIFI Blinking WLAN works normally with data transmission.
• If you want to use the mobile network to connect to Internet, you
WLAN works abnormally, or this WLAN
need to insert your (U)SIM card first. OFF
function is disabled.
• Your device does not support Micro/Nano or any other nonstandard
SIM cards. To avoid device damage, please do not use them. Off Not in use.
On Dialing, or there is an incoming call, the
PHONE Blinking
phone is ringing.
On In calling.
ON WAN connection established (PDP activated)
Blinking WAN connection establishing (PDP activating)
PPP
WAN connection not established (PDP not
OFF
activated).
RF signal is normal (RSSI >= -90dBm).
Different color indicates different network.
ON
Red: GSM/GPRS/EDGE.
Green: HSDPA/HSUPA/UMTS.
2G/3G
Normal states of the indicators are shown below:
RF signal is poor (-100dBm <= RSSI <
Blinking
-90dBm).
Indicator State Description
OFF RF signal is not available (RSSI < -100dBm).
ON External power supply is connected normally.
ON The corresponding LAN port is connected
POWER
External power supply is disconnected or
OFF
power off.
The corresponding LAN port is connected
LAN Blinking
with data transmission.
Off No network cable connected.
Configuring Your PC
3. Select Internet Protocol (TCP/IP), and then click Properties.
Follow the following steps and figures for Windows XP to configure the
Internet Protocol for your connection.
NOTE:
• Wireless Network Connection is used for Wi-Fi connection.
• Local Area Connection is used for Network Cable connection.
1. Right-click My Network Places, and then select Properties.
4. Select these two items, and then click OK to finish the configuration.
2. Right-click the icon for Connection, and then select Properties.
Accessing the Internet
Before accessing the Internet, please make sure:
• Your device is connected via network cable or Wi-Fi.
• Your PC is configured.
To access the Internet:
1. Log in the WebGUI Configuration Page.
1) Launch the Internet browser and enter http://192.168.0.1 in the
address bar. The login page appears.
NOTE:
If you select Bridge mode, you need to connect your clients to the LAN
ports via Ethernet cable, and use normal methods to surf directly on your
clients. If you want to use other operation mode after Bridge, you need to
restore your device.
3. Configure Settings.
NOTE: This step is used for Cable Broadband mode and Wireless
Broadband mode.
• For Cable Broadband mode
NOTE: In this mode, you can only use Wi-Fi to connect to your device.
Please select PPPoE, set the PPPoE parameters, and then click
u
Apply.
NOTE: Your service provider gives you the User Name and Password.
2) Input the password (the default password is admin), and then
click Login.
2. Select current mode Change.