Alarm-Out; Spot-Out Setup; Controller & Ptz Setup - Panasonic X-Plus Series SP-DRH04 User Manual

CHANNEL
MOTION ZONE Select either Full Zone or Partial Zone for motion sensing.
MOTION SENSITIVITY Set the motion sensitivity for the specified channel.
PRIVACY ZONE Select the privacy zone through mouse drag (Left-up to right
KEY TONE
REMOTE CONTROL ID
SENSOR
VIDEO INPUT TRIMMING ON (Display 960x 576), OFF (Display 944 x 576). Select this

3-4-1. ALARM-OUT

Item
ALARM OUT
ALARM DURATION
3-4-2 Controller & PTZ Setup
To control the PTZ functions of the camera, connect a controller to the RS-485 port.
①
Connect the RS-485 cables of PTZ camera to the RS-485 port on the rear panel.
Select specified channel for motion zone setup.
Control the motion sensitivity from 1(L) to 9(H).
down). To escape from this setting page, select Quite after
press the right button on the mouse.
Enable/disable key tone.
Select an ID of remote control.
1. Select ID.
2. Press the same number as ID set in DVR on a remote control
3. Then icon will be displayed on Live screen of DVR that
respond to the remote control. The options are from 0 to 99
Select sensor Number from 1 to 4
TYPE Set the type of sensor for the specified channel. Options are:
OFF, N/O (normal open), and N/C (normal closed).
menu after checking the right inputting camera resolution
Figure 3.4.2. ALARM-OUT setup screen
Table 3.4.2. Menu item in ALARM-OUT Setup screen
Available Number is just one (1).
Set the alarm dwell time from 5 seconds to infinite.
Description
29