Roll Pivot Adjustment - jaeco WREX Setup Instructions

Roll Pivot Adjustment

1. Using the large T-Wrench loosen the screw
for the Roll Pivot Adjustment.
2. With the aid of the bubble level roll the
adjustment medially or laterally until the
bubble is centered.
3. Tighten the Roll Pivot Adjuster Screw.
4. Using the large T-Wrench tighten all six of
the Mount Link Clamp Screws and the two
Mount Shaft Base Screws.
5. Recheck that the bubble in the level is still
centered. Adjust the Pitch Pivot or Roll Pivot
as necessary.
Caution: Do not put the clients arm into the orthosis until all
previous steps in this section have been completed.
4-3