Mount Screw; Preparing Backrest And Mount Base; 2-11: Mount Base Attachment - jaeco WREX Setup Instructions

For use on some Permobil and Other Seating Systems

Mount Screw

Reinforcement
Washer

Preparing Backrest and Mount Base

1. Remove backrest cushion.
2. Tape the template on the back of the backrest 1 ½ to
2 inches down from upper edge and as close to the
midline as possible.
Note: Place Base Drill Template on flattest area of
backrest
4. Use drill bit supplied and drill the two marked holes.
5. Orient the Arm Mount Base as shown in illustration.
Insert the Mount Base Screw (supplied with
Arm Mount Base) thru the Attachment Hole to
the MR-7 Mount Adapter. Using large T-Wrench
secure these two parts.
MR-7
Mount Base Installation
MR-7
Mount Base
Adapter
Arm Mount Base
Locking Knob
2-10
Alignment Slot
Attachment Hole