2-4: Mount Base Attachment; 2-6: Mr-8 Mount Base Attachment - jaeco WREX Setup Instructions

Mount Base Attachment
1. In this open position, apply the mount to the
wheelchair upright (back post).
Note: Mount positioning (angle) will vary depending on
wheelchair style.
2. Position the mount so that the top of the mount is
not more than 6 inches below the top of the clients
shoulder.
3. Tighten Base Clamp Screws.
Do not tighten Jaw Locking Set Screws at this
time.
Note: Adjustments in position may be necessary for
optimal function.
4. Loosen but do not remove the Locking Knob
on the Arm Mount Base.
5. Position the Mount Link so that the Alignment
Pin in the Arm Mount Shaft is aligned with
the Alignment Slot of the Arm Mount Base.
Insert the shaft into the base and tighten the
Locking Knob.
6. Preposition the Mount Links so that the
Shaft Mount Base that receives the Pitch
Mount Shaft is located in the lateral 1/3 of
the clients torso on the side which you
intend to use the WREX Arm.
2-4