Pioneer DEH-P440 Service Manual page 50

1
- How to remove the Control Unit
1. Give jumper-solder treatment to the Flexible Wire of
the Pickup unit, then remove the wire from the
Connector.
A
2. Remove all 4 points of solder-treatment on the Lead
Wire. Also, unscrew the screw(1 piece).
3. Then, Remove the Control unit.
(Caution)
Be careful not to damage SW when you reassemble
the Control Unit into the device.
- How to remove the Loading Arm Assy
1. Unlock the spring (1 piece) and remove the E ring (1
B
piece) of the Fulcrum Shaft.
2. Shift the arm to the left side direction and unlock pins
(2 pieces).
C
- How to remove the Pickup Unit
1. Unscrew 2 pieces of screws, then remove the Pulley
Cover.
2. Remove the Feed Screw unit from the pawl of the
Feed Screw Guide (The pawl is located inside the
guide).
3. Remove the belt from the Pulley, then remove the
Pickup unit.
(Caution)
Make sure not to stain the belt with gr
fix the belt.
D
50
1
2
Control Unit
Loading Arm Assy
Grease Application
Pulley Cover
ease when you
DEH-P440/XN/UC
2
3
Jumper-Solder
GEM1035
Pickup Unit
Grease Application
GEM1035
3
4
Solder
UD321BR
Grease Application
Belt
Feed Screw Guide
4