Door Assembly Installation Or Removal Instructions - Lennox Hearth Products Shoreline 33/40 DV INS Installation And Operation Manual

SHORELINE™ DOOR ASSEMBLY INSTALLATION OR REMOVAL
INSTRUCTIONS
Tools Needed: No tools are needed
Cat. No. Description
H5746 Shoreline Door Assembly (Figure 9)
Shoreline Door Kit - Packaging List
Models SHR33 & SHR40
Quantity
1
Table 6 - (refer to Figure 9)
Note: The Shoreline insert comes with the door already on the
unit. Just reverse the steps here to remove the door to access
the burner area.
Figure 9
1. Locate three tabs on the bottom of the door. These tabs will go into
the tab slots along the bottom of insert. See Figure 10.
Figure 10
2. Drop the door into the three tab slots on the bottom of the insert as
shown in Figure 11. The door should be at a 25 degree angle to the
front of the insert to be able to place the door correctly.
1
Description
Shoreline Door Assembly
Tab
NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE
Figure 11
3. Pull the louvers out to the farthest point and then lift up. Push door
against the face of the insert. Drop the louvers down and let the
springs pull the three latches into the three slots located on the top
of the insert. See Figure 12.
Figure 12
4. Figure 13 shows the insert with the door in place.
Figure 13