Leica 2 User Manual page 17

Now press F1 CONT to confirm the
selection of the newly created job.
Finally you have to select the an-
tenna type and and antenna setup
which you are using. Normally this
will be AT502 on tripod (or AT501 on
tripod in case of a SR510 sensor).
This selection is made in the usual
way: first use the cursor down key to
get this input field highlighted. Then
use the cursor left or right key to
toggle between all available types
until the right one appears. Alterna-
tively you can press the ENTER key
to get a listbox from which the choice
can be made.
Now all required settings for a static
survey are made. The Survey \ Begin
panel looks as follows:
Press F1 CONT to finishe this start-
up sequence.
17
Step 5: Logging raw data
We are now within the main Survey
panel. The way the sensor is cur-
rently configured this panel will look
as follows: