Page 1
Write the serial number in the space above for future reference. Serial Number Decal (inside tower) QUESTIONS? At FreeMotion Fitness, we are committed to providing com- plete customer satisfaction. If you have questions, see HOW TO CONTACT CUSTOMER CARE on the back cover of this manual.
35 or persons with pre-existing health problems. Read all instructions before using. FreeMotion Fitness assumes no responsibility for personal injury or property damage sustained by or through the use of this product.
WARNING DECAL PLACEMENT The decals shown below have been placed on the strength equipment in the indicated locations. If a decal is missing or illegible, see HOW TO CONTACT CUSTOMER CARE on the back cover of this manual to order a free replacement decal.
BEFORE YOU BEGIN Thank you for selecting the FREEMOTION ® EPIC™ after reading this manual, see HOW TO CONTACT CHEST strength equipment. The strength equipment’s CUSTOMER CARE on the back cover of this manual. To stylish ergonomic design and never-before-seen fea- help us assist you, please note the product model tures improve upon traditional strength training.
ADJUSTMENT This section explains how to adjust the strength equipment. Make sure all parts are properly tightened each time the strength equipment is used. Replace any worn parts immediately. ADJUSTING THE RESISTANCE To change the amount of resistance for your workout, insert the weight pin into the desired weight.
Personnel must also record and report any accident. To maintain the strength equipment’s warran- ty, use only FREEMOTION EPIC parts for repair or replacement. If there are any questions or concerns, see HOW TO CONTACT CUSTOMER CARE on the back cover of this manual.
Page 8
Cable Guards plates. If there is not enough tension on the cables, Check the cable guards to ensure that they are not the top weight will not be lifted immediately when the rubbing against the cables and that they are holding repetition is begun.
Page 9
Tower Pulley Adjustment Top Weight Adjustment Tools required: 5/16" hex key, 9/16" open end wrench Tools required: 5/32” hex key 1. Lift the top weight off the 1. If the cable needs to be shortened 3/4 in. (2 cm) weight stack and insert the or more, follow the instructions in steps 1 and 2 at weight pin into the second the left;...
Page 10
WEIGHT STACK SERVICING 8. Replace the top weight. Next, tighten the rod nut, rod star washer, and rod washer onto the weight Servicing the weight stack involves replacing the two rod. guide bushings and weight insert in the top weight. To order these parts, see HOW TO CONTACT CUS- 9.
CABLE DIAGRAM The cable diagram below shows the proper route of the cables. Use the diagram to make sure that the cables and the cable guards have been assembled correctly. If the cables have not been correctly routed, the strength equipment will not function properly and damage may occur.
PART LIST—Model No. GZFI8003.6 R1006A If replacement parts are needed, or if parts are missing or damaged, see HOW TO CONTACT CUSTOMER CARE on the back cover of this manual. Key No. Qty. Description Key No. Qty. Description Frame Cover Internal Pivot Bushing Short Tower Plate Right Arm...