Summary of Contents for Freemotion Epic GZFI8063.5
Page 1
Serial No. Write the serial number in the space above for future reference. Serial Number Decal (inside tower) QUESTIONS? At FreeMotion Fitness, we are committed to providing com- plete customer satisfaction. If you have questions, see HOW TO CONTACT CUSTOMER CARE on the back cover of this manual.
35 or persons with pre-existing health problems. Read all instructions before using. FreeMotion Fitness assumes no responsibility for personal injury or property damage sustained by or through the use of this product.
WARNING DECAL PLACEMENT The decals shown below have been placed on the strength equipment in the indicated locations. If a decal is missing or illegible, see HOW TO CONTACT CUSTOMER CARE on the back cover of this manual and order a free replacement decal.
BEFORE YOU BEGIN Thank you for selecting the FREEMOTION ® EPIC™ after reading this manual, see HOW TO CONTACT FLY/REAR DELT strength equipment. The strength CUSTOMER CARE on the back cover of this manual. To equipment’s stylish ergonomic design and never-before- help us assist you, please note the product model seen features improve upon traditional strength training.
ADJUSTMENT This section explains how to adjust the strength equipment. Make sure all parts are properly tightened each time the strength equipment is used. Replace any worn parts immediately. ADJUSTING THE RESISTANCE To change the amount of resistance for your workout, insert the weight pin into the desired weight.
Personnel must also record and report any accident. To maintain the strength equipment’s warran- ty, use only FREEMOTION EPIC parts for repair or replacement. If there are any questions or concerns, see HOW TO CONTACT CUSTOMER CARE on the back cover of this manual.
Page 8
Cable Guards plates. If there is not enough tension on the cables, Check the cable guards to ensure that they are not the top weight will not be lifted immediately when the rubbing against the cable and that they are holding repetition is begun.
Page 9
WEIGHT STACK SERVICING 8. Replace the top weight and the weight pin on top of the weight stack. Servicing the weight stack involves replacing the two guide bushings and the weight insert in the top weight. 9. Reattach the “U”-bracket to the weight rod with the To order these parts, see HOW TO CONTACT CUS- bolt, the two washers, and the locknut.
CABLE DIAGRAM The cable diagram shows the proper route of the cable. Use the diagram to make sure that the cable Cable (24) and the cable guards have been assembled correctly. If the cable has not been correctly routed, the strength equipment will not function properly and damage may occur.
PART LIST—Model No. GZFI8063.5 R1106A If replacement parts are needed, or if parts are missing or damaged, see HOW TO CONTACT CUSTOMER CARE on the back cover of this manual. Key No. Qty. Description Key No. Qty. Description Base Short Panel Frame Tower 1/4"...