Sony SAL28F28 Service Manual page 15

HELP06
Adhesive bond (B-40): J-6082-614-A
1. Hook the main spring to the hook of rear light shield barrel tube and the hook of preset ring holding plate.
2. Attach the rear light shield barrel tube to the lens mount riveting block, apply the bond (B-40) to the screwed portions of three screws
shown in figure, and tighten screws.
3. Attach the ground spring to the rear light shield barrel tube and fix the main flexible unit with two screws.
Note:
Be careful not to tighten screws too strongly.
Confirm that the preset ring holding plate moves smoothly.
Apply the adhesive bond(B-40)
Lens Mount
Riveting Block
Preset Ring
Holding Plate
SAL28F28 (2.8/28) (28mm F2.8)
Main Flexible Unit
Ground Spring
Apply the adhesive bond(B-40)
Rear Light Shield Barrel Tube
Main Spring
HELP