Kenmore 795.77192600 Service Manual page 30

8-1-14 TEST Mode
1. The Test mode allows checking the PCB and the function of the components as well as finding out the defective part in
case of an error.
2. The test mode is operated by pressing two buttons at Display panel.
3. While in the test mode, the function control button is not recognized, but the recognition tone (beep~) sounds.
4. After exiting the test mode, be sure to reset by unplugging and then plugging in the appliance.
5. If an error, such as a sensor problem, is detected while in the test mode, the test mode is cleared and the error code is
displayed.
6. While an error code is displayed, the test mode will not be activated.
* Freezer Fan RPM Variable Check:
In case the freezer fan is in operation when the Ultra Ice button and freezing temp. button. Control are pressed for more
than one second at the same time freezer fan RPM changes. (for example if high speed, to normal speed or if normal
speed, to high speed for 30 seconds)
After 30 seconds, it turns to its original RPM.
* Demonstration MODE:
1. When the Ultra Ice button and the Refrigerator Temperature Control button are pushed at the same time and hold for 5
seconds or longer, it converts to Demonstration Mode.
2. The Display shows the Demo graphic.
3. In this status, all Loads are off (Compressor / Fan / Damper / Heater)
(Even is Demonstration Mode, the refrigerator Lamp automatic off function warks normally and can be demonstrated)
4. Exit Demonstration mode and reset Display by pressing the Ultra Ice button and the Refrigerator Temperature Control
button for 5 seconds or longer.
- 30 -