Installation - Electrolux WA GL4 E 201 User Manual

Problem
The appliance makes
an unusual noise.
The appliance fills with
water and drain imme-
diately.
The cycle is shorter
than the time dis-
played.
The cycle is longer
than the time dis-
played.
The washing results
are not satisfactory.
After the check, activate the appliance. The
programme continues from the point of in-
terruption.
If the problem occurs again, contact the
service centre.
If the display shows other alarm codes,
contact the service centre.
SERVICE

INSTALLATION

FIXING PLATE KIT (4055171146)
Available from your authorized dealer.
If you install the appliance on a plinth, se-
cure the appliance in the fixing plates.
Follow the instructions supplied with the kit.
Possible cause
Incorrect level of the appli-
ance.
You did not remove the pack-
aging and/or the transit bolts.
The load is very small.
The end of the drain hose is
too low.
The appliance calculates a
new time according to the
laundry load.
An unbalanced laundry load
increases the duration time.
The detergent you used was
not sufficient or correct.
You did not remove the stub-
born stains before you wash
the laundry.
Incorrect temperature was set.
Too much laundry load.
Mod. ... ... ...
Prod. No. ... ... ...
Ser. No. ...
Possible solution
Adjust the level of the appliance. Refer
to 'Installation'.
Remove the packaging and/or the trans-
it bolts. Refer to 'Installation'.
Add more laundry in the drum.
Make sure that the drain hose is in the
correct position.
See the 'Consumption Values' chapter.
This is a normal behaviour of the appli-
ance.
Increase the detergent quantity or use a
different one.
Use special products to remove the
stubborn stains.
Make sure that you set the correct tem-
perature.
Decrease the laundry load.
Refer to the information supplied with this
appliance for guarantee condition and point
of contact. The information to give to the
service is on the rating plate.
We recommend that you write the information
here:
Model
(MOD.)
Product number
(PNC)
Serial number
(S.N.)
UNPACKING
1. Use the gloves. Remove the external
film. If necessary, use a cutter.
electrolux 21
..................
..................
..................