Pin Entry Setupmode - Lathem PayClock PC400TX Installation & User Manual

14 - PC400 Terminal Installation & User's Guide

PIN Entry SetupMode

The PIN Entry Setup Mode allows you to enable or disable PIN entry from the keypad.
PIN entry enables your employees to key in their badge number when punching instead
of swiping their badge. With PIN entry enabled employees can do either, swipe their
badge or key in their badge number.
To Enable PIN entry press 752902 on the keypad.
To Disable PIN entry press 752902 on the keypad.
Note: The 752902 code toggles PIN entry on or off. If you disable PIN entry, press [*]
after the last digit is entered to return to a normal display
Press the Status button on the keypad to check your settings, this screen will display
VER
ID#
MEM
UPD
LOAD LIST
or
CLK READY
use
BAUD
PIN
DST
This completes the setup. The terminal is ready to accept a download. For more
information on downloading to the PC400/PC400TX see the PayClock software users
guide or the on line help.
Note: If your PC400TX was discovered and configured using the Terminal Manager
software you will see the terminals IP address display after the above Status screen.
Firmware version of your clock
Number used to identify your clock
Percentage of memory used
Identifies the firmware patch version
Ready to be updated from the PayClock software
Clock has been updated from the PayClock software and is ready to
Baud rate setting 9600 or 2400
ENAB = enabled / DISAB = disabled
ON= Daylight savings is on / OFF = Daylight savings is off
When PIN entry is enabled this screen will display:
PIN ENAB.
When PIN entry is disabled this screen will display:
PIN DISAB