Lincoln Electric 2006 Navigator Owner's Manual page 184

Locks and Security
Please read and understand the entire procedure before you begin.
1. Insert the first previously
3
programmed coded key into the
ignition and turn the ignition from
2
the 1 (OFF/LOCK) to the 3 (ON)
position [maintain ignition in 3 (ON)
4
for at least three seconds, but no
more than ten seconds].
2. Turn ignition from 3 (ON) back to
1
the 1 (OFF/LOCK) position in order
to remove the first coded key from
the ignition.
3. Within ten seconds of removing the first coded key, insert the second
previously programmed coded key into the ignition and turn the ignition
from the 1 (OFF/LOCK) to the 3 (ON) position [maintain ignition in
3 (ON) for at least three seconds but no more than ten seconds].
4. Turn the ignition from the 3 (ON) back to 1 (OFF/LOCK) position in
order to remove the second coded key from the ignition.
5. Within 10 seconds of removing the second coded key, insert the new
unprogrammed key (new key/valet key) into the ignition and turn the
ignition from the 1 (OFF/LOCK) to the 3 (ON) position [maintain
ignition in 3 (ON) for at least three seconds, but no more than ten
seconds]. This step will program your new key to a coded key.
6. To program additional new unprogrammed key(s), repeat this
procedure from Step 1.
If successful, the new coded key(s) will start the vehicle's engine and the
theft indicator will illuminate for three seconds and then go out.
If not successful, the new coded key(s) will not start the vehicle's engine
and the theft indicator will flash on and off and you may repeat Steps 1
through 5. If failure repeats, bring your vehicle to your authorized dealer
to have the new spare key(s) programmed.
183
2006 Navigator (nav)
Owners Guide (post-2002-fmt)
USA (fus)