Lincoln Electric 2006 Navigator Owner's Manual page 126

Lights
To change the back-up lamp bulbs:
1. Make sure the headlamp switch is
in the OFF position.
2. Remove the liftgate trim panel by
removing the two trim bolts in the
grab handle.
3. Remove the retaining nuts from
the license plate housing to expose
the bulb socket.
4. Turn the bulb socket
counterclockwise and pull it out of
the back-up lamp assembly.
5. Pull out the old bulb and replace it by pushing in a new bulb.
6. Push the connector back into the back-up lamp assembly and turn it
clockwise to secure it in place.
7. Reinstall the liftgate trim panel.
Replacing liftgate tail lamp bulb
1. Make sure the headlamp switch is
in the OFF position.
2. Raise the liftgate and remove the
two retaining nuts on the underside
of the liftgate.
3. Pull the lamp assembly straight
out (it will snap out of a plastic
retaining grommet).
125
2006 Navigator (nav)
Owners Guide (post-2002-fmt)
USA (fus)