Lincoln Electric 2006 Navigator Owner's Manual page 168

Table of Contents

Advertisement

To reset the power liftgate:
1. Manually close and fully latch the liftgate.
2. Power open the liftgate by using the keyfob or overhead console
button.
3. Once the liftgate is fully open, close the liftgate using the keyfob or
overhead console button.
Note: If the power liftgate system is turned <OFF> in the message
center, the system cannot be activated with any switches or with the
liftgate handle. The system will need to be turned <ON> for any power
operation to occur.
Liftgate ajar signal
If the liftgate or liftgate glass are not fully latched, you will receive a
"LIFTGATE or LIFTGLASS AJAR" message on the instrument panel. If
you see this message, check both the liftgate glass and liftgate door to
insure they are fully latched.
Make sure the liftgate is closed to prevent exhaust fumes from
being drawn into the vehicle. If you must drive with the liftgate
open, keep the vents open so outside air comes into the vehicle.
MANUAL LIFTGATE (IF EQUIPPED)
To open the rear window, push the
button on the left side of the liftgate
handle above the license plate.
To open the liftgate, pull the liftgate
handle.
• Do not open the liftgate or
liftgate glass in a garage or other
enclosed area with a low ceiling.
If the liftgate glass is raised and
the liftgate is also opened, both
liftgate and glass could be damaged against a low ceiling.
• Do not leave the liftgate or liftgate glass open while driving. Doing so
could cause serious damage to the liftgate and its components as well
as allowing carbon monoxide to enter the vehicle.
2006 Navigator (nav)
Owners Guide (post-2002-fmt)
USA (fus)
Driver Controls
167

Advertisement

Table of Contents
loading

Table of Contents