Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for DogWatch BigLeash V-10
Summary of Contents for DogWatch BigLeash V-10
- Page 1 BigLeash ® REMOTE TRAINER Vibration Trainer Owner’s Guide...
- Page 2 Thank You for Purchasing ® by DogWatch R E M O T E T R A I N E R ® ® At DogWatch , “It’s all about your dog. ” You can be assured that you have purchased one of the most technologically advanced pet training products available.
-
Page 3: Table Of Contents
Troubleshooting ..................12 Warranty & Service ................14 Programming the Receiver Collar............16 ® DogWatch offers a full range of pet containment and training solutions, including Outdoor Hidden Fences, Indoor Boundaries and Remote Trainers. Our Hidden Fence is rated a “Best Buy” by Consumers Digest. -
Page 4: Charging The Transmitter And Receiver Collar
Charging the Transmitter and Receiver Collar ULLY CHARGE THE TRANSMITTER AND THE RECEIVER BEFORE USING THE FIRST TIME The batteries take approximately 3-4 hours to charge. We recommend charging your transmitter and receiver when not in • use. A protection circuit prevents overcharging. Battery Status Indicators Battery Icon Icon = low battery... -
Page 5: Turning The Transmitter And Receiver On And Off
Connecting the transmitter and receiver to the charger Connect the ‘Y’ cord to the Lift the protective tab on Lift the protective tab on the power adapter to charge the the back of the receiver bottom of the transmitter to transmitter and receiver at to insert the charger. -
Page 6: Receiver Features
Receiver Features ® The BigLeash receiver provides a battery status light and the Firefly nightlight to help you keep track of your dog at night. Battery Status Light* Firefly Nightlight Strips Battery Status Light Blinks Turned on, charged GREEN Blinks Turned on, low battery Steady Plugged-in, charging... -
Page 7: Transmitter Features
Transmitter Features BigLeash uses exclusive digital FM technology with In-Touch™ two-way ® communication between the transmitter and the receiver collar. Lanyard Loop Antenna LCD Display Vibration Level Collar 1/Collar 2 Adjustment Switches signal from Lowest Collar 1 to Collar 2 Highest Collar 1 Collar 2... - Page 8 Lanyard Loop A lanyard is supplied with each transmitter. Antenna/Range Information Your BigLeash Vibration Trainer provides a mile range in optimal conditions. Range will vary depending on environmental conditions such as terrain, weather, vegetation, buildings and other obstructions. For best results, hold the transmitter with the antenna pointed up. Pointing the antenna at the dog will not increase the range or the signal strength.
- Page 9 LCD Display Collar /Collar Icon Indicates which collar is receiving the signal when working with 2 dogs. Collar 1 Collar 2 Receiver Icon (Paw) Signal Strength Vibration Level Transmitter Icon Example 1 Example 2 Transmitter Low Battery Icon Receiver Icon Signal Strength (Paw) Indicates that the receiver collar is...
- Page 10 Collar / Collar Feature Your transmitter comes set for use with one dog but can easily be programmed for two dogs. If you are working with two dogs, you will need two receiver collars. See page 16 for information about adding the second collar. The Collar 1 and Collar 2 buttons allow you to change commands between the two collars.
-
Page 11: Bigleash Vibration Training
BigLeash Vibration Training Vibration training allows you to use the vibration signal from the remote trainer as a stand-in for the traditional leash to accomplish your training objectives. The goal is to achieve off-leash control aided and reinforced by the remote trainer. Training is accomplished by using the vibration signal to simulate the different pulling pressures usually associated with the leash during normal walking or training exercises. -
Page 12: Training Basics
Training Basics The ‘Look’ Command The ‘Look’ Command is the foundation of BigLeash training. Your goal is to train your dog to respond to the vibration signal by directing his attention to you, even when he is not close enough to hear your verbal command. When you have his attention, you can then successfully deliver other commands. - Page 13 • Pull gently on the leash to get your dog’s attention. s soon as you begin to pull, give the “Look” command while pressing the ((V)) button. • As soon as your dog makes eye contact release the ((V)) button and the pressure from the leash.
-
Page 14: Troubleshooting
Troubleshooting The Remote Trainer Does Not Seem To Be Working Check to make sure the batteries in both the transmitter and the • receiver are charged. Check to see that both the transmitter and receiver are turned “on”. • Note: The transmitter and receiver will not turn on when charging. If fully charged but not turning on, press the ((V)) button on the transmitter •... - Page 15 For battery questions or replacement, please contact Customer Service: (800) 793-3436 x622 M-F, 9am-5pm EST - or - Email: bigleash@dogwatch.com No Communication Link The link can usually be restored by turning the system off and then turning it •...
-
Page 16: Warranty & Service
The Company’s sole responsibility under this warranty will be to repair or replace, at its option, the product or part which DogWatch Inc. determines to be defective. In no event will the Company be liable for any special, indirect, or consequential damages arising out of the purchase or use of the product. - Page 17 Warranty Procedures and Guidelines DogWatch Inc. provides a one (1) year limited warranty from the date of purchase on both parts and labor for the transmitter, receiver and battery charger. Warranty does not cover repairs or replacement due to misuse by the owner or dog, improper maintenance or lost units.
-
Page 18: Programming The Receiver Collar
Programming the Receiver Collar Adding a Second Collar Your transmitter is pre-set for use with one dog but can easily be programmed for use with two dogs. Collar 2 has a red collar strap and has a small “Dog 2” sticker on the back so that you can differentiate Collar 1 from Collar 2. - Page 19 (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by DogWatch, Inc., could void the user’s authority to operate the equipment.
- Page 20 Bring out the best in your dog. www.dogwatch.com DogWatch, DogWatch logos and BigLeash are Registered Trademarks of DogWatch, Inc. DogWatch products are lead-free and compliant with the Reduction of Hazardous Substances (RoHS) initiative. The Consumers Digest logo and Best Buy Seal are registered trademarks of Consumers Digest and used under license.
Need help?
Do you have a question about the BigLeash V-10 and is the answer not in the manual?
Questions and answers