Indoor Unit Installation; Outdoor Unit Installation - Daikin CDXS25BVMB Installation Manual

INDOOR UNIT INSTALLATION

ITemporarily install the indoor unit.
G
Attach the hanger brackets to the suspension bolts. Be
sure to use nuts and washers both above and below
the hanger brackets to secure them.
NOTE) Use washers when mounting with M8 bolts.
IUse a water level or water-filled vinyl tubes to
check that the unit is level at all four corners as
shown in the drawing.
ITighten the top nuts.
IMounting the signal receiver
Mount the signal receiver as shown below.
Press the signal
1
receiver into the
insulated mounting
frame.
Note) Mount the remote control cord far enough away from strong electrical wires (such as distribution wires for electrical
lights, air conditioners, etc.) and from weak electrical wires (such as wires for telephones, intercoms, etc.).
For heat pump: If your feet feel cold when using the heating
function, it is recommended that the air
discharge grill shown at right be attached.

OUTDOOR UNIT INSTALLATION

Install as described in the installation manual supplied with the Multi outdoor unit.
Press the signal receiver
2
and mounting frame into
the faceplate frame and
secure with two screws.
Nut (commercially available)
Washer (commercially available)
Tighten
(two nuts)
Water level
Mount the Press the
3 4
completed faceplate onto
assembly using the faceplate
two screws. frame.
Vinyl tube
Press the
5
decorative
cover into the
faceplate.
(Adjustable
45°
angle)
4