Kenwood TK-2360 Service Manual page 8

TK-2360
3. Mounting the Chassis to the Case
Assembly
1. Mount the holder q to the chassis w.
Confi rm that the holder is securely locked to the chassis.
2. Insert the packing e to the phone jack side of the chas-
sis.
Confi rm the mounting direction of packing.
Confi rm that the packing is securely inserted to the chas-
sis and SP/MIC jack.
3. Insert the packing r to the chassis.
Confi rm that the packing is securely inserted to the chas-
sis and that it does not protrude out.
4. Insert the upper part of the chassis into the case assem-
bly t.
5. Press the chassis and the case assembly together to at-
tach them.
BWN
GRE
RED
BLK
8
DISASSEMBLY FOR REPAIR
4. Attaching the Antenna Receptacle to
the Chassis
Screw the antenna receptacle to the chassis in the order
shown in the drawing so that the antenna receptacle
comes to the center of the case hole.
Tighten this screw first.
Tighten this screw second.
5. The Nuts of the Volume Knob and
Channel Knob
Note that the shapes and heights of nuts of the volume
knob and channel knob are different from one another.
Use the following jig when removing the nuts of the vol-
ume knob and channel knob.
• Jig (Part No.: W05-1012-00)
Volume knob
(Long)
Channel knob
(Short)