Table of Contents
Advertisement
12
| HD Portal User Manual 3.1
See below for a list of the available commands.
For more information on external control, please refer
to the MediaPOINTE Command Line Interface document.
Telnet
The telnet client within the HD Portal provides access
to the Command Line Interface through the TCP/
IP protocol. By default, telnet is enabled but can
be disabled from the web interface. The available
commands are the same as those listed in the RS-232
section.
To access the telnet client, open a command prompt on
your computer and enter: telnet <ipaddress>
Once connected to the HD Portal, the following
message will be displayed.
HD Portal Welcome to MediaPOINTE
Password:_
audio gain
help or ?
author
input
bye/quit
ipassign
cli
ipset
copyme
ipstat
defaultProfile
key
displayres
limit
displayratio
listfiles
file info
list Profiles
Once logged in, type 'help' or '?' for a list of
commands.
Infra-Red (IR) Receiver
The Infra-Red (IR) jack for use with the handheld
remote control is located on the back of the HD Portal.
It can also be used for IR control via control systems
such as AMX or Crestron.
April 2013
multicast
shutdown
multicast_ttl
smtp
notify
status
play
sysinfo
playstatus
test
reboot
usersec
record
volume
rename
resetconf
Advertisement
Table of Contents
