Rinse Aid - Bosch Dishwasher Operating Instructions Manual

To Close
• Place finger as shown in Figure 3.
• Slide door closed and press down firmly
until it clicks.
To Open
• To open the cover, push the button as
shown in Figure 4. Cover will slide open.

Rinse Aid

Your dishwasher was designed to use rinse aid
for best drying results. To achieve proper drying,
always use a liquid rinse aid, even if your deter-
gent contains a rinse aid or drying additive.
Note: The dishwasher indicates low rinse aid by
turning on the "Add Rinse Aid" indicator light. If this
light is on, you need to refill the rinse aid dispenser
by following the directions below. If the light is not
on, your dishwasher still has enough Rinse Aid and
there is no need to refill it.
Adding Rinse Aid
Add liquid rinse aid to the dispenser until it is full
(see Figure 5). Wipe up any excess rinse aid that
may puddle when the dispenser reservoir is full.
Lid must be snapped fully closed in order to
seal. The indicator light will go out a few
moments after the dishwasher door is shut. See
below for instructions on how to adjust the
amount of rinse aid dispensed.
Note: Setting the rinse aid to "r:00" may increase
cycle times.
Setting the amount of rinse aid
The amount of rinse aid dispensed can be set from "r:00" to "r:06".
1 Press the [On/Off] button.
2 Hold down the "A" button (see page 15) and press [Start] until the
display indicates "d:00". Release both buttons.
3 Press the "A" button until the display shows "r:05".
4 Press the "C" button to select the desired setting.
"r:00" = dispenser is OFF
"r:01" = lowest setting
"r:02" = low setting
"r:03" = medium setting
5 Press [Start] to save the setting.
11
"r:04" = medium/high setting
"r:05" = high setting
"r:06" = highest setting
Figure 3
Figure 4
Figure 5