Table of Contents
Advertisement
TROUBLESHOOTING
Heart rate doesn't display on watch
- The chest belt may not be positioned correctly.
- The grooved sensors may not be wet enough,
wet and try again.
- It is recommended that the grooved sensors
are directly on your skin.
Heart rate reading on watch is inconsistent or stops
- The battery may need to be replaced in the chest belt.
- Sources of electromagnetic fields can cause
interference. (Appliances, computers, and power lines)
Watch beeps continuously
- If the zone alarm is on and your heart rate is not in any
of the zone ranges, the watch will beep to indicate you
are out of the zones.
Watch display may be frozen due to static electricity
- The display may be frozen due to static electricity
or recent battery replacements, If this occurs, press on
all 4 side buttons at the same time to reset to factory
settings.
CARE & MAINTENANCE
Avoid extreme force, shock, dust temperature,
or humidity. Such conditions may cause
malfunctioning, a shorter electronic lift span,
damaged batteries, or distorted parts.
Rinse the watch with fresh water to avoid materials
building up that can interfere with the reception of
the pulse.
Do not use abrasive or corrosive materials to clean
the watch or chest belt. Abrasive cleaning agents
may scratch the plastic parts and corrode the
electronic circuit..
Avoid tampering the internal components of the
watch. Doing so will terminate the sensors warranty
and may cause damage.
ENGLISH
17
Advertisement
Table of Contents
