Lincoln Electric INVERTEC V350-PRO Service Manual page 110

F-60
MAIN SWITCH BOARD REMOVAL & REPLACEMENT (continued)
207
J21
PROCEDURE
1. Remove the input power to the V350-PRO.
2. Using a 5/16" nut driver remove the case wrap-
around cover.
3. Perform the Input Filter Capacitor Discharge
Procedure detailed earlier in this section.
CAUTION
Observe static precautions detailed in PC Board
Troubleshooting Procedures at the beginning of
this section. Failure to do so can result in perma-
nent damage to equipment.
4. Locate the main switch board and all associat-
ed plug and lead connections. See figure F.22.
See Wiring Diagram.
TROUBLESHOOTING & REPAIR
FIGURE F.22. – MAIN SWITCH BOARD LEAD LOCATIONS
- +
201
208
- +
203
202
- +
204
205
- +
206
5. Using a 5/16" and 3/8" nut driver remove the
input lead shield from the area at the bottom of
the main switch board.
6. Using a 7/16" socket, remove leads 201, 202,
203, 204, 205, 206, 207, 208, 209 from the
switch board. Note lead terminal locations and
washer positions upon removal.
7. Locate and disconnect the three harness plugs
associated with the main switch board. Plugs
#J20, #J21, #J22. See Figure F.22.
8. Locate the eight capacitor terminals and
remove the nuts using a 7/16" socket or nut
driver. Note the position of the washers behind
each nut for replacement.
V350-PRO
F-60
J22
209
J20