Related Manuals for White's SIERRA GOLD TRAC
Summary of Contents for White's SIERRA GOLD TRAC
- Page 1 ’ WNER UIDE IERRA White’s Electronics, Inc. - Manufacturers of the World’s Finest Metal Detectors...
- Page 2 Sierra Gold Trac Owner’s Guide ASSEMBLY - Search coil Lower rod Arm cup Rubber Clevis washers (2) Cam-lock fi ber bolt Battery door 5. Grip the instrument by the handle, with your 1. Remove all parts from the shipping carton and check arm in the elbow cup with strap and sweep the assembly diagram to ensure all parts are present.
- Page 3 Sierra Gold Trac Owner’s Guide Super Quick Start Instructions - 1 - 2- 3- GO GAIN CONTROL KNOB Turn the Gain Control clockwise until the Power goes on. Then with the Search Coil in the air rotate the Gain Control clockwise to a point between 7 & 8 (suggested setting triangle)
- Page 4 / right to left. Then the signal is from a metal target and you should investigate it by digging it. REMEMBER , the Sierra Gold Trac, is an ALL MET- AL detector.
- Page 5 Sierra Gold Trac Owner’s Guide Controls: Threshold- The THRESHOLD control knob sets the loudness of the background “Hum”. This background hum must be maintained at ALL times when searching. In order to hear the tiniest and deepest targets the THRESHOLD “hum” should be set at the faintest audible level that you can hear. It can be slightly scratchy, chattery or static like, but it must be constant, so as not to miss small or deep nuggets.
-
Page 6: Pinpoint Technique
Sierra Gold Trac Owner’s Guide The object of increasing the Gain adjustment is to get the maximum available depth from the detector WITHOUT causing noise interference or overload of the circuit from ground mineralization. A very impor- tant function of the Threshold Hum is to be the audio “monitor” of the proper setting of the GAIN control. If the threshold hum blanks out frequently while sweeping the coil, your Gain control is probably set too high. -
Page 7: Warranty
Sierra Gold Trac Owner’s Guide Warranty- If within two years (24 months) from the original date of purchase, your White’s detector fails due to de- fects in either material or workmanship, White’s will repair or replace at its option, all necessary parts without charge for parts or labor. - Page 8 White’s Electronics, Inc. 1011 Pleasant Valley Road Sweet Home, Oregon 97386 USA 541-367-6121 www.whiteselectronics.com White’s metal detectors are proudly designed, built, and tested in Sweet Home, Oregon USA by the employees of White’s Electronics, Inc. Part Number 621-0545 cb 5/13...
Need help?
Do you have a question about the SIERRA GOLD TRAC and is the answer not in the manual?
Questions and answers