Related Manuals for White's Sierra Super Trac
Summary of Contents for White's Sierra Super Trac
- Page 1 ’ wner uide ® ierra uper White’s Electronics, Inc. - Manufacturers of the World’s Finest Metal Detectors...
- Page 2 Sierra Super Trac Owner’s Guide ASSEMBLY - 1. Remove all parts from shipping carton and check to 7. Remove the protective paper from the two black make sure the kit is complete. elbow cup foam pads. Carefully align pads on the inside of the elbow cup, one on each side of the 2.
- Page 3 Sierra Super Trac Owner’s Guide Super Quick Start Instructions - - - 3- GO PINPOINT TRIGGER UNDER GRIP Set to center SEARCH position AUTO-TRAC TOGGLE Set to Normal (initial setting triangle) GAIN CONTROL KNOB Set between 9 & 10 (initial setting triangle) Pump the coil up and down over the ground a few times and start detecting by swinging the search coil as indicated on the graphic drawing below.
-
Page 4: Quick Start Instructions
Sierra Super Trac Owner’s Guide Quick Start Instructions (full)- 1. Set the Auto Trac Toggle to the Normal “preset triangle” position. 2. Be sure the Trigger Switch (under hand grip) is in the center (search) position. 3. Turn the Gain control knob clockwise until the power clicks ON. Rotate the Gain Control clockwise to the “preset triangle”... -
Page 5: Visual Display
Sierra Super Trac Owner’s Guide Visual Display- The ST display and reference label below the display pro- vide a wealth of information about the metal target. The display information works best after the solid repeatable audio”beep”. The display will momentarily show a software version and battery voltage immediately after the SENS knob is turned “on”. - Page 6 Sierra Super Trac Owner’s Guide Visual Display Continued- Half block indicates target I.D. is not certain. 2. Blocks- A series of 16 blacks appear along the bottom portion of the display and line up with the indications on the reference label below the display.
- Page 7 Sierra Super Trac Owner’s Guide Controls- 1. Trigger (on bottom of Hand Grip) CENTER POSITION “Search” - With the two position spring loaded Trigger on the hand grip in the center, the ST is in the Search Posi- tion. In this position ALL metal targets will produce an Audio Response from a menu of seven different tones which relate to the VDI numbers which appear on the Visual Display.
- Page 8 Sierra Super Trac Owner’s Guide Controls Continued- 2. Auto Trac Toggle (on top right face of control box) The Auto- TRAC Toggle selects the type of ground mineral rejection (ground balance) and automatic track- ing to ground mineral changes best suited to the specific area. Three different positions, each for a specific ground condition are provided.
- Page 9 Sierra Super Trac Owner’s Guide Controls Continued- 3.GAIN Control/ ON- OFF Knob (on top left face of control box) “The Single Most Important Control on any Metal Detector” The GAIN control knob turns the instrument on/off and selects the Receive Signal strength. In essence this control sets the “sensitivity”...
- Page 10 White’s Electronics, Inc. 1011 Pleasant Valley Road Sweet Home, Oregon 97386 USA 541-367-6121 www.whiteselectronics.com Part Number 621-0504 crb 2/13...