Denon AVR-5803 Operating Instructions Manual page 26

Av surround receiver
Hide thumbs Also See for AVR-5803:
Table of Contents

Advertisement

9
After the above settings are completed, press jog stick "ENTER"
The "Channel Level" screen reappears.
Press jog stick "ENTER" again to return to the System Setup Menu screen.
3% To cancel the settings, select "Level Clear" and "Yes" on the "Channel Level" screen, then make the settings again
The level of each channel should be adjusted to 75 dB (C-weighted, slow meter mode) on a sound level meter at the listening position
If a sound level meter is not available adjust the channels by ear so the sound levels are the same. Because adjusting the subwoofer level test
tone by ear is difficult, use a well known music selection and adjust for natural balance.
NOTE:
When adjusting the level of an acttve subwoofer system, you may also need to adjust the subwoofer's own volume control.
% When you adjust the channel levels while in the SYSTEM SETUP CHANNEL LEVEL mode, the channel level adjustments made will affect
ALL surround modes. Consider this mode a Master Channel Level adjustment mode.
% After you have completed the SYSTEM SETUP CHANNEL LEVEL adjustments,
you can then activate the individual surround modes and
adjust channel levels that will be remembered for each of those modes. Then, whenever you activate a particular surround sound mode,
your preferred channel level adjustments for just that mode will be recalled. Check the instructions for adjusting channel levels within each
surround mode on page 48.
I You can adjust the channel levels for each of the following surround modes: DIRECT, STEREO, 5CH/7CH STEREO, DOLBY/DTS SURROUND,
HOME THX CINEMA, WIDE SCREEN, SUPER STADIUM, ROCK ARENA, JAZZ CLUB, CLASSIC CONCERT, MONO MOVIE, and MATRIX.
% When using either surround speakers A or B, or when usrng surround speakers A and 6 at the same time, be sure to adjust the balance of
playback levels between each channel for the various selections of "A or B" and "A and B".
Make these settings when "Yes" is selected for the subwoofer in the Speaker Configuration settings
There is not displayed when "No" selected. (page 20)
1
Select "THX Audio Setup" on the System Setup Menu screen
System
Setup
Menu
Speaker
Configuration
Delay
Time
Channe I Leve I
FTHX Audio
Setup
Subwooftr Peak
Limit
Lev.
Digital
In Assignment
;ideo
Input
Mode
2
Nmmu
Press jog stick "ENTER" to switch to the THX Audio Setup screen
Select "Boundary Gain Compensation",
then press
jog stick "ENTER".
THX Audio
Setup
uBoundary
Gain
Compensation
Surround
Back
Speaker
Position
Exit
I
26

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents