Urban BFX770 Operating Instructions Manual page 7

SETTING UP
ASSEMBLY INSTRUCTIONS FOR WHEELS
TO STORE THE HEATER
1. Remove the regulator from the gas cylinder.
2. Inspect the cylinder for any damage. If you suspect that your
cylinder is damaged, return it to your gas supplier.
3. Store the gas cylinder in a well ventilated area.
4. Never store the gas cylinder below ground i.e. basement.
10
STEP-BY-STEP PROCEDURE
STEP 4 :
4-1 Fit the LPG hose onto the burner
gas inlet connector as shown.
4-2 Tighten the jubilee clip around the LPG
hose and gas inlet connector.
4-3 Thread the hose down the post assembly.
4-4 Fix the burner base vertically with
the post ensuring the instruction label is
below the ignitor and facing same direction.
STEP 5 :
5-1 Install 4 pieces of M6 x 10mm bolts
and tighten each one.
5-2 Locate hose at base of pole and
thread on a jubilee clip.
5-3 Fit the regulator supplied to hose and attach
jubilee clip and tighten as shown.
STEP 6 :
6-1 Put 3 pieces of reflector washers onto
the burner reflector support.
6-2 Place the single piece reflector onto the
burner reflector support and align the holes.
6-3 Take 3 wing nuts with a washer on each
hole and screw into holes to tighten.
7