Table of Contents
Advertisement
Quick Links
Urban Industry Limited
Thor Industrial Estate
Braydon Lane
Cricklade
SN6 6HQ
Tel: +44 (0) 1793 613900
Email: sales@patioheaters4u.com
Registered in England No. 4682994
Copyright©2003/13 Urban Industry Limited. All rights reserved.
www.patioheaters4u.com
Printed in the UK
Model No:
BFX770
Terrace & Patio Heater
Operating Instructions
Safety Information........................2
Assembly Parts..........................4
Setting Up..................................6
Heater Stand & Location................9
Leakage Testing........................11
Operation & Storage...................12
Before Requesting Help.............13
Technical Data & Specifications 14
Guarantee................................ 15
Certified
Please retain this manual for reference
Advertisement
Table of Contents
Summary of Contents for Urban BFX770
-
Page 1: Operating Instructions
Technical Data & Specifications 14 SN6 6HQ Guarantee……...………………….. 15 Tel: +44 (0) 1793 613900 Email: sales@patioheaters4u.com Registered in England No. 4682994 Certified Copyright©2003/13 Urban Industry Limited. All rights reserved. www.patioheaters4u.com Please retain this manual for reference Printed in the UK... -
Page 2: Safety Information
1. Immediately turn off gas to the appliance. 2. Extinguish any open flame. workmanship or materials, Urban Industry Ltd will undertake to repair 3. If you still smell gas, call your gas supplier. or replace subject to the following conditions: 4. -
Page 3: Technical Data And Specifications
TECHNICAL DATA & SPECIFICATIONS PLEASE READ THE SAFETY GUIDELINES PRIOR TO OPERATION OF THE HEATER • This outdoor gas appliance is for outdoor use only and must not be used in a building, garage or any enclosed area. FOR OUTDOOR USE ONLY •... -
Page 4: Problem Solving
ASSEMBLEY PARTS & PROCEDURE PROBLEM SOLVING Parts supplied: PROBLEM PROBABLE CAUSE SOLUTION LPG cylinder housing Pilot will not light Gas valve may be OFF Turn gas valve ON Post assembly with 3 piece post bracket Cylinder fuel empty Refill LPG cylinder Opening blocked Clean pipes... -
Page 5: Operation & Storage
PARTS & SPECIFICATIONS OPERATION & STORAGE TO TURN ON THE HEATER 1. Cylinder Base 1. Push and turn the gas control knob counter-clockwise 90 ° and hold it. 2. At the same time press the igniter until the flame comes on. Note: If a 2. - Page 6 STEP-BY-STEP PROCEDURE CAUTION & LEAKAGE TEST PRECAUTIONS STEP 1: Periodically check the whole gas system for leaks or immediately if the smell of gas is detected. Wheel Fitting Extinguish all open flames. If fitting wheel assembly please refer to page 10 ...
- Page 7 SETTING UP STEP-BY-STEP PROCEDURE ASSEMBLY INSTRUCTIONS FOR WHEELS STEP 4 : 4-1 Fit the LPG hose onto the burner gas inlet connector as shown. 4-2 Tighten the jubilee clip around the LPG hose and gas inlet connector. 4-3 Thread the hose down the post assembly. 4-4 Fix the burner base vertically with the post ensuring the instruction label is below the ignitor and facing same direction.
-
Page 8: Heater Stand And Location
STEP-BY-STEP PROCEDURE SETTING UP STEP 7 : HEATER STAND AND LOCATION • The heater is for outdoor use only. Always ensure adequate fresh 7-1 Access the gas storage area by raising the gas cylinder housing and placing it on top of the post bracket. air ventilation.