Frame Schematic Diagram; Printed Wiring Boards And Schematic Diagrams - Sony SLV-KS1 Service Manual

PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS

THIS NOTE IS COMMON FOR PRINTED WIRING
BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed
in each block.)
For printed wiring board:
X : indicates a lead wire mounted on the component
•
side.
x : indicates a lead wire mounted on the printed side.
•
b : Pattern from the side which enables seeing.
•
(The other layers' patterns are not indicated.)
SECTION 4
For schematic Diagram:
• Caution when replacing chip parts.
New parts must be attached after removal of chip.
Be careful not to heat the minus side of tantalum capacitor,
because it is damaged by the heat.
• All resistors are in ohms,
less otherwise specified.
kΩ : 1000Ω, MΩ : 1000kΩ.
• All capacitors are in µF unless otherwise noted. pF : µµF
50V or less are not indicated except for electrolytics and
tantalums.
• All variable and adjustable resistors have characteristic curve
B, unless otherwise noted.
2 : nonflammable resistor.
•
5 : fusible resistor.
•
C : panel designation.
•
f
• : internal component.
U
• : B+ Line.
V
• : B– Line.
• Circled numbers refer to waveforms.
• Voltages are dc between measurement point.
• Readings are taken with a color-bar signal input.
• Readings are taken with a digital multimeter (DC 10MW).
• Voltage variations may be noted due to normal production
tolerances.
Note:
The components identi-
fied by mark 0 or dotted
line with mark 0 are criti-
cal for safety.
Replace only with part
number specified.
When indicating parts by reference
number, please include the board
name.
4-1
SLV-KS1
1 1
/ W (Chip resistors : / W) un-
4 10
Note:
Les composants identifiés par
une marque 0 sont critiques
pour la sécurité.
Ne les remplacer que par une
pièce portant le numéro
spécifié.