Land Pride All Purpose Seeder APS1548 Operator's Manual page 4

Important Safety Information
These are common practices that may or may not be applicable to the products described in
this manual.
Use Safety
Lights and Devices
Slow moving tractors,
self-propelled equipment, and
towed implements can create a
hazard when driven on public
roads. They are difficult to see,
especially at night.
Flashing warning lights and turn
signals are recommended
whenever driving on public roads.
Use A Safety Chain
A safety chain will help control
drawn machinery should it
separate from the tractor
drawbar.
Use a chain with the strength
rating equal to or greater than
the gross weight of the towed
machinery.
Attach the chain to the tractor
drawbar support or other
specified anchor location. Allow
only enough slack in the chain
to permit turning.
Do not use safety chain for
towing.
2 APS1548, APS1560, APS1572 & APS1586 All Purpose Seeder 313-354M
Table of Contents
Transport
Machinery Safely
Comply with state and local laws.
Maximum transport speed for
implement is 20 mph. DO NOT
EXCEED. Never travel at a speed
which does not allow adequate
control of steering and stopping.
Some rough terrain require a
slower speed.
Sudden braking can cause a
towed load to swerve and upset.
Reduce speed if towed load is not
equipped with brakes.
Practice Safe Maintenance
Understand procedure before doing
work. Use proper tools and
equipment, refer to Operator's
Manual for additional information.
Work in a clean dry area.
Lower the implement to the ground,
put tractor in park, turn off engine,
and remove key before performing
maintenance.
Allow implement to cool.
Use the following maximum
speed - tow load weight ratios as
a guideline:
20 mph when weight is less
than or equal to the weight of
tractor.
10 mph when weight is double
the weight of tractor.
IMPORTANT: Do not tow a load
that is more than double the
weight of tractor.
Do not grease or oil implement
while it is in operation.
Inspect all parts. Make sure parts
are in good condition & installed
properly.
Remove buildup of grease, oil, or
debris.
Remove all tools and unused
parts from implement before
operation.
10/13/11