RAB Lighting GNLED13Y Instruction Manual

Input
Lumens Watts
GNLED13Y 556 16
with Flood Refl ector & Frosted Lens
GNLED13YS 571 16
with Spot Refl ector & Clear Lens
GNLED13YR 535 16
with Rectangular Refl ector & Clear Lens
GNLED13N 643 15
with Flood Refl ector & Frosted Lens
GNLED13NS 643 15
with Spot Refl ector & Clear Lens
GNLED13NR 604 15
with Rectangular Refl ector & Clear Lens
Additional Lighting Facts labels see www.rabweb.com
Pat. Pending
Note: These instructions do not cover all details or variations in equipment
nor do they provide for every possible situation during installation, operation
or maintenance.
Color
Effi cacy(LPW) CRI Temp(K)
36 86 3000K
37 86 3000K
35 86 3000K
43 87 4000K
43 87 4000K
40 87 4000K
GOOSENECK LED INSTRUCTIONS
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE
INSTRUCTIONS FOR FUTURE REFERENCE.
RAB fi xtures must be wired in accordance with the National Electrical Code and
all applicable local codes. Proper grounding is required for safety. THIS PRODCUT
MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION
CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF
THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING: Make certain power is OFF before installing or maintaining fi xture.
No user serviceable parts inside.
Housing Mounting
1. Thread the Bushing onto the Arm.
2. Feed leads through the Arm.
3. Mount Housing to Bushing with
three set screws. Check that
Bushing Gasket is seated properly.
4. Tighten all Set Screws.
5. Loosen Swivel Screw and adjust
fi xture to desired angle. Tighten
Swivel Screw.
6. To ensure weatherproof seal use
Tefl on tape on Arm threads or use
weatherproof silicone sealant be-
tween Arm and Bushing
Arm Mounting to Wall and Wiring
1. Insert arm into Wall Plate.
Tighten Set Screws.
2. Make supply wiring connections in
recessed box with UL approved
connectors.
3. A universal voltage driver permits
operation at the following voltages,
50 or 60Hz.
13W 120V thru 277V
4W 120V thru 240V
4. Mount Wall Plate to the wall with
hardware appropriate for your
mounting surface.
5. To ensure weatherproof seal, apply
weatherproof silcone sealant around
the edge of the Wall Plate. This is
especially important with an uneven
wall surface.
Thank you for buying RAB lighting fi xtures. Our aim is to design the best quality products to
get the job done right. We'd like to hear your comments. Call the Marketing Department at
888-RAB-1000, or email: marketing@rabweb.com
Arm
Bushing
Gasket
Bushing
Swivel
Screw
Housing
Wall Plate
Set Screws
Set Screws (6)
Optional
Photocell
1