Cateye stealth 50 cyclocomputer CC-GL50 Instruction Manual page 28

6
Click on [STEALTH] to change the settings.
Before changing the settings, click on [Read] to load the settings of the computer.
Delete the data recorded
in the computer.
Change the settings according to the following procedure.
Setting items
Select the city code nearest from your current location.
Time zone
* For details, see "Time zone list" (page 11).
Select whether to use the daylight saving time.
Daylight saving
• On : Moves the clock 1 hour ahead.
time
• Off : Displays in regular clock.
Speed unit Select the speed unit (km/h or m/h).
Set the time when the backlight lights up.
• Night-time setting ON : Enter the start time when the backlight lights up.
• Night-time setting OFF : Enter the end time when the backlight lights off.
(Example) When lighting up from 7:00 pm to 6:00 am
Night-time set-
Night-time setting ON : 19
ting
Night-time setting OFF : 6
* When you do not want to turn on the backlight throughout the day,
set the same value for both "Night-time setting ON" and "Night-time
setting OFF".
Read the current settings
of the computer.
Description
Setting items
This setting is required when you pair the ANT+ speed sensor
or speed/cadence (ISC) sensor.
Assign the tire circumference to the speed sensor or speed/cadence
sensor whichever you pair.
(Setting range: 0100 to 3999 mm)
• ISC1 (ISC:1) : Speed/cadence sensor 1
Tire circumfer-
• SPD1 (SP:1) : Speed sensor 1
ence
• ISC2 (ISC:2) : Speed/cadence sensor 2
• SPD2 (SP:2) : Speed sensor 2
* As default, it is set to 2096.
* For the sensor without pairing, the tire circumference cannot be set
even if it is entered.
* ISC2 and SPD2 are used when a computer is commonly used for
two bicycles.
For details, see "Pairing the sensor" (page 32).
You can enter the start value of the total distance, and add the trip
distance to it.
Total distance (Setting range: 00000 to 99999)
* This can be used when you renew and/or reset the computer.
* Enter the total distance in integer number only.
Set the record interval of the measurement data.
* The maximum recording time (total time of all trip data) and the
Sampling inter- maximum time for one trip depend on the interval selected.
val
• 1s (at intervals of 1 second) : 35 hours / 12 hours
• 2s (at intervals of 2 seconds) : 70 hours / 24 hours
• 5s (at intervals of 5 seconds) : 175 hours / 60 hours
Select the display format of "12h" (12 hours display) or "24h" (24
hours display).
Clock display
format
* Date and clock are acquired from GPS signal; therefore, it is not
necessary to enter them.
7
Click on [Apply].
The changes are reflected to the computer.
Remove the computer from the cradle. Now, changing the computer configuration is
completed.
Description
28