Battery Preparation (Except Battery Without Maintenance); Checks Before Handing Over To The Customer - PEUGEOT Geopolis 250 Workshop Manual

SERVICE SCHEDULE AND COMMISSIONING

Battery preparation (Except battery without maintenance)*

Remove the battery.
Remove the 6 filler caps and the vent plug.
Fill with electrolyte to the level marked "UPPER LEVEL".
Electrolyte: (35% sulfuric acid = 1.28g/cm3).1 litre can P/N 752740; 5 litre can P/N 752741.
Leave the battery to stand for around half an hour.
Top up if necessary.
Charge the battery for at least 2 hours with a current of 0.4A.
Refit the battery and connect the vapour vent pipe.
Connect the red wire lug to the battery's + terminal, and the green wire lug to the battery's - terminal.
Then, the battery level should be topped up if necessary, after fully charging, using distilled water only.

Checks before handing over to the customer

Check the wheel nuts are tight.
Check nuts and bolts are tight.
Check brake adjustment and efficiency.
Check the tyre pressures cold.
Check operation of the lights, flashers, horn, and brake light.
Check the different warning lights work.
Carry out a road test.
* Depending on equipment.
8
Reproduction ou traduction, même partielle, interdite sans autorisation écrite de Peugeot Motocycles