Installation - Zanussi ZBB28651SA User Manual

Problem
The temperature in the ap-
pliance is too high.
Replacing the lamp
The appliance is equipped with a longlife LED
interior light.
Only service is allowed to replace the lighting
device. Contact your Service Center.
Closing the door
1. Clean the door gaskets.

Installation

Caution! Read the "Safety Information"
carefully for your safety and correct
operation of the appliance before installing the
appliance.
Positioning
Install this appliance at a location where the
ambient temperature corresponds to the cli-
mate class indicated on the rating plate of the
appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Electrical Connection
Caution! Any electrical work required to
install this appliance should be carried
out by a qualified electrician or competent
person.
Warning! This appliance must be
earthed.
The manufacturer declines any liability should
these safety measures not be observed.
8
Possible cause
The temperature regulator is not
set correctly.
Set a lower temperature.
2. If necessary, adjust the door. Refer to "In-
stallation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
A
Important! The wires in the mains lead are
coloured in accordance with the following
code:
A Green and Yellow:
C Brown:
D Blue:
As the colours of the wires in the mains lead of
this appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
1. Connect the wire coloured green and yel-
low to the terminal marked either with the
Solution
B
C
D
E
Earth
Live
Neutral
www.zanussi.com