Zanussi ZBB28651SA User Manual

Zanussi ZBB28651SA User Manual

Refrigerator zanussi zbb28651sa
Hide thumbs Also See for ZBB28651SA:

Advertisement

User manual
EN
Refrigerator
ZBB28651SA

Advertisement

Table of Contents
loading

Summary of Contents for Zanussi ZBB28651SA

  • Page 1 User manual Refrigerator ZBB28651SA...
  • Page 2: Table Of Contents

    • If this appliance featuring magnetic door less flammable. seals is to replace an older appliance having a spring lock (latch) on the door or lid, be www.zanussi.com...
  • Page 3 • Make sure that the mains plug is accessible ance are special purpose lamps selected for after the installation of the appliance. household appliances use only. They are not • Connect to potable water supply only (If a suitable for household room illumination. water connection is foreseen). www.zanussi.com...
  • Page 4: Control Panel

    Quick Freeze button again. To operate the appliance, proceed as follows: The Quick Freeze indicator will light off. • touch the temperature regulator button until Important! the LED corresponding to the required tem- This function stops automatically after 52 hours. www.zanussi.com...
  • Page 5: First Use

    It is therefore recommended to keep uids in the refrigerator citruses in separate containers. • do cover or wrap the food, particularly if it Butter and cheese: these should be placed in has a strong flavour special airtight containers or wrapped in alumi- www.zanussi.com...
  • Page 6: Care And Cleaning

    • defrost (if foreseen) and clean the appliance After cleaning, reconnect the equipment to the and all accessories mains supply. • leave the door/doors ajar to prevent un- Defrosting of the refrigerator pleasant smells. Frost is automatically eliminated from the evaporator of the refrigerator compartment ev- www.zanussi.com...
  • Page 7: What To Do If

    The melting water outlet does not Attach the melting water outlet to ground. flow in the evaporative tray above the evaporative tray. the compressor. The temperature in the ap- The temperature regulator is not Set a higher temperature. pliance is too low. set correctly. www.zanussi.com...
  • Page 8: Installation

    1. Connect the wire coloured green and yel- low to the terminal marked either with the www.zanussi.com...
  • Page 9 Ventilation requirements The airflow behind 5 cm min. 200cm the appliance must be sufficient. min. 200cm Installing the appliance Caution! Make sure that the mains cable can move freely. Do the following steps: www.zanussi.com...
  • Page 10 (C, D) to the lugs hinge cover (E). and the hinge holes. Install the vent grille Make sure to remove the part DX, in the (B). Attach the hinge cov- case of right hinge, SX in opposite case. ers (E) to the hinge. www.zanussi.com...
  • Page 11 • The magnetic sealing strip is attached tight- ly to the cabinet. Important! If the ambient temperature is low (for example, in the Winter), the size of the gasket decreases. The size of the gasket increases when the ambient temperature increases. www.zanussi.com...
  • Page 12: Noises

    Noises There are some sounds during normal running (compressor, refrigerant circulation). HISSS! BRRR SSSRRR! SSSRRR! HISSS! HISSS! www.zanussi.com...
  • Page 13: Technical Data

    Width 560 mm Depth 550 mm Rising Time 22 h Voltage 230-240 V Frequency 50 Hz The technical information are situated in the rating plate on the internal left side of the ap- pliance and in the energy label. www.zanussi.com...
  • Page 14 www.zanussi.com...
  • Page 15 www.zanussi.com...
  • Page 16 www.zanussi.com/shop...

Table of Contents