Table of Contents
Advertisement
Available languages
Available languages
TROUBLESHOOTING
Problem
Possible cause
No display LED on
Power cord
the front panel;
not plugged in correctly
No power supply
No pictures on the screen
Receiver in Standby mode;
SCART not connected tightly
to video output of television;
incorrect channel or video
output selected on television
No sound
Audio cord connected
incorrectly;
Volume level = 0;
Muting active
Remote Control does not
Batteries dead or inserted
operate directly
incorrectly
Poor picture quality
Signal strength too low
On-Screen Error Message
Antenna cable not connected
"Searching for signal"
or not tight;
incorrect position of the
signal;
On-Screen Error Message
Receiver not yet set
"Channel data does not
exist."
On-Screen Error Messages:
Smartcard:
"Please check the
- not plugged in correctly;
Smartcard";
- not plugged in.
"Please insert the
Smartcard".
On-Screen Error Messages:
No access to this channel
"No access"
DISPOSAL
The device, packaging material (e.g. Styrofoam) and the batteries must never be disposed
of with household refuse.
Please obtain appropriate information about the regulations in your community, and dispose
of all refuse in accordance with regulations at the separate locations provided.
GB-28
Solution of the problem
Power cord plug in correctly
Set receiver to "On";
Check connection and correct;
Check channel and video output and
correct (TV instruction manual)
Check connection and correct;
Increase volume on television set;
Press the MUTE key
Point remote control towards the
Receiver.
Replace batteries or insert correctly
Check the signal strength in
the "Installation" menu, correct
alignment of your signal cable
Check connection and correct;
Check position and correct,
Check the signal strength in
the "Installation" menu
Scanning of in "Installation" menu
(depend on model)
Check the Smartcard.
"Insert the Smartcard."
Check that you subscribe to this channel.
If the STB has been switched off for a
longer period of time, turn on the STB,
select any channel, and wait for
authorization for up to 60 minutes.
D
I
G
I
T
A
L
C
TECHNICAL SPECIFICATIONS
Power supply
Type :
Input Voltage :
Fuse rating :
Power Consumption :
Stand by :
Tuner & Demodulator
Input Frequency :
DEMODULATION :
SYMBOL RATE :
Constellation :
CABLE OUT :
Video decoder
System decoding :
Profile and level :
Data rate :
Video formats :
Picture resolution :
Audio Decoder
System decoding :
Audio mode :
Sampling frequency :
N N o o t t e e
: The specification of the STB may be changed without notice in advance.
A
B
L
E
R
E
C
E
I
V
E
R
SMPS
AC 100 - 240V~, 50/60 Hz
250 V/T1.6 AH
Max. 10W
7W
VHF,UHF BAND(50~870 MHz)
QAM DVB-C
MAX 7 Msps
16, 32, 64, 128, 256 QAM
LOOPOUT FOR ANALOG RECEIVER
MPEG 2 ISO/IEC 13818
(Transport Stream)
MPEG 2 MP@ML (4:2:2)
1~ 15 Mb/s
4:3 (normal) & 16:9 (widescreen)
720(H) x 576(V) x 50 fields/sec
MPEG 1 ISO/IEC 11172~3 layer I & II
single channel, dual channel, stereo,
joint stereo
32, 44.1, 48 KHz
GB-29
Advertisement
Chapters
Table of Contents
