Before First Use - AEG FAVORIT34502VIO User Manual

How to set the water softener
level
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold the programme button until the
indicator
the indicator
on with fixed light.
2. Wait until the indicator
indicator
indicator
The intermittent flashing of the
indicator
level.
• E.g. 5 flashes + pause + 5 flashes =
level5.
3. Press programme button again and
again to change the setting. Each
time you press programme button
the level number increases. After
level 10 you will start again from level
1.
4. Press the on/off button to confirm
the setting.
6.3 Acoustic signals
Acoustic signals sound when a
malfunction of the appliance occurs. It is
not possible to deactivate these acoustic
signals.
There is also an acoustic signal that
sounds when the programme is

7. BEFORE FIRST USE

1. Make sure that the current level of
the water softener agrees with the
hardness of the water supply. If
not, adjust the level of the water
softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any
processing residuals that can still be
inside the appliance. Do not use
detergent and do not load the
baskets.
starts to flash and
comes
goes off and the
starts to flash. The
continues to flash.
refers to the current set
completed. By default this acoustic
signal is deactivated but it is possible to
activate it.
How to activate the acoustic
signal for the end of
programme
The appliance must be in programme
selection mode.
1. To enter the user mode, press and
hold the programme button until the
indicator
the indicator
on with fixed light.
2. Press immediately the programme
button.
• The indicator
fixed light.
• The indicator
flash.
3. Wait until the indicator
off. The indicator
continues to flash.
• The end indicator indicates the
current setting: End indicator off =
Acoustic signal off.
4. Press the programme button to
change the setting.
• End indicator on = Acoustic signal on.
5. Press the on/off button confirm the
setting.
When you start a programme, the
appliance can take up to 5 minutes to
recharge the resin in the water softener.
It seems that the appliance is not
working. The washing phase starts only
after this procedure is completed. The
procedure will be repeated periodically.
ENGLISH 9
starts to flash and
comes
comes on with
starts to
goes